Description

A range of technologies can be integrated to meet the varied requirements of Power Distribution Units within armoured vehicles, these range from conventional electro-mechanical through to fully digitised.

With a variety of options for power switching, connectors, monitoring and interfaces together with an expandable architecture and flexible packaging design, specific customer requirements can be met.

Features

• High current interfaces to batteries, main engine generator, auxiliary power unit generator and vehicle electrical system
• Power switching (solid state, conventional electro-mechanical)
• Protection against short circuit, over current and over temperature
• Intelligent power monitoring (current consumption, open circuit load detection)
• Galvanically isolated CAN 2.0B interfaces, supports MilCAN, CANopen, J1939 and other Higher Layer Protocols
• Galvanically isolated RS422/RS485 interfaces
• RS232 interface supporting full duplex communication. This interface is also used to up-load new program or configuration data to the node
• Bus enabled ETI and serial number record available
• BIT

< Back to Products

Specification

Input Voltage: 28V to Def Stan 61-5 Part 6
Current: Requirement dependent
Operating Temperature: -40 to +49°C
Storage Temperature: -46 to +71°C
Dimensions: Requirement dependent
Operating Environment: Designed to Def Stan 00-35 (Tracked Vehicle)
Finish: Requirement dependent
EMC: Designed to Def Stan 59-41